52 Tooth Conversion Kit
54 Tooth Coversion Kit
- 40% more clamping force at Hgh RPM. (Clutch pull becomes heavier as RPM increases.)
- Smoother shifting, easier to find Neutral.
- 10 minute installation.
- Install through the derby cover without removing the primary cover.
- Fits behind the stock derby cover.
- Can be use with cable and hydraulic clutch controls.
Trask ARP high strength cylinder stud kit is a must for any high output engine or turbo build. Perfect for use with oversized cases, these 7/16 thread studs are much stronger compared to the OEM 3/8 thread studs that can be pulled out of the case in High Performance engine builds. Proudly made in the USA at our Phoenix, AZ facility.
This is not your typical air cleaner. With its clear plexiglas cover, and hidden integrated breather system, this Hi-flow air cleaner was designed to give a clean, simple, & aggressive look, made to stand out in a crowd. Introducing a new Nick Trask innovation, every Assault Charge Hi-flow air cleaner comes with the new Trask snap in velocity stack. This simple interchangeable snap in velocity stack can be changed quickly and easily to accommodate different sized throttle bodies. Clean and easy to maintain with a rechargeable filter element as well as dyno tested in house producing 8-10 horsepower gains over the stock OEM air cleaner.
- Proudly made in the USA at our Phoenix, AZ facility.
- Available in Chrome, Black, Reverse Cut and Raw finishes
- Fits H-D M8 Touring / Softail Models, Twin Cam EFI Throttle by Wire, & Twin Cam EFI/Carburetor Throttle by Cable
|Twin Cam||Throttle By Wire|
|Twin Cam||EFI Cable|
|M8||Touring / Softail|
The Trask Big Power Head Bolt Kit is designed to strengthen up your engine while providing a custom build look to your engine. Made using only the highest quality alloy and chrome plated, these kits are available for both Harley twin cam motors and S&S motors. Proudly made in the USA at our Phoenix, AZ facility.
|S&S (8 Long)||2401-0894|
|H-D (4 Long, 4 Short)||2401-0895|
Stop messing around with failing and unreliable OEM fuel pressure regulators…
Upgrade to the Trask fuel pressure regulator housing!
- Proudly made in the U.S.A.
- Anodized red.
- Machined from billet aluminum.
Fits 2001-2007 H-D Softails & 2002-2007 H-D Touring models
DRAG P/N (1009-0025 RED)
Our high flow injectors come in every Trask Turbo Kit and will support 250+ horsepower motors. If you are looking for high flow injectors for your big motor build, look no further. Designed to run 8.69 GPS and 30 degree spray pattern for better atomization, these injectors are an excellent addition to any big motor build. (V-Rod owners be aware you will need to run our billet fuel rail with these injectors).