Trask V-Rod Intercooler Upgrade
Upgrade your Trask Turbo Kit on your V-Rod with a Trask intercooler upgrade.
By adding an intercooler to your Trask turbo kit you will gain even more horsepower by increasing the density of the air going into your engine.
Installation is clean and add’s a new dynamic to the look and feel of your Turbo V-Rod
Kit contains all the hardware and instruction for an easy installation.
Re-chargeable replacement filter for your Trask V-Rod Turbo. These high flow filters are designed and made exclusively for our turbo systems. You can use any recharge kit on the market for these filters. Pre-Filter (rainsock) available to protect your filter from rain and road debris.
The Trask High-Flow fuel pump fills the need for the additional fuel required to run those high boost, high horsepower numbers on our custom turbo kits. Proudly made in the USA at our Phoenix, AZ facility.
-Kit comes with all the hardware and instructions needed for installation.
The Trask V-Rod billet fuel rail is designed for use with any deka fuel injector and to give you more options than the destroyer injector. When paired with our Trask high flow injectors (add $350.00), this set-up will support 200+ horsepower. Proudly made in the USA at our Phoenix, AZ facility.
-Fits 02-17 V-Rod models
Low compression pistons are ideal for forced induction applications running higher boost pressures over 8psi on the revolution motor. Our forged pistons are designed specifically for forced induction. Big Bore for 1250cc V-Rod engines. Proudly made in the USA at our Phoenix, AZ facility.
The Trask Custom Spec, Billet 1018 steel stud girdle. This crank girdle is the strongest precision fit girdle available for the Revolution motor. Designed to eliminate bottom end flex in crank area. A must have, for any serious high performance V-Rod engine build. Proudly made in the USA at our Phoenix, AZ facility.
-Trask ARP Girdle Stud Kit included